|
|
|
|
|
|
|
|
|
| System On Module sbc-9263 |
|
|
|
|
System on Module with MCU Atmel AT91SAM9263, status: Active
SBC-9263 is a low-power, system-on-module (SOM) based on Atmel at91sam9263. It is supplied with production-ready Linux 2.6 Board Support Package (BSP). The module is designed in 200-pin SODIMM form-factor with dimensions just 67x47x4 mm.
The module architecture delivers enough performance to design a GUI based industrial controls or multimedia system with sound processing like MP3-players. The SBC-9263 evaluation does not need any special development tools like JTAG or IDE. Atmel supplies free of charge AT91 In-system Programmer (ISP), which provides an open set of tools for programming Atmel® AT91SAM ARM® Thumb®-based microcontrollers. The compiler for Linux is open source and requires no royalties. Our WIKI help system is full of instructions for initial power-up of SOM and describes software development procedures under Linux.
Atmel at91sam9263 MCU brings high resolution GUI to your embedded systems. We supply a few types of industrial displays ready to connect to SBC-9263 based boards. You can watch the ME-MS1000B Development kit with SBC-9263 running the Angstrom Linux demo at our Video gallery.
|
Technical details :
- ARM926EJ-S-based MCU AT91SAM9263 @200 MHz
- 64MB 32bit SDRAM on EBI0
- 64MB NOR Flash
- 10/100 Mb Ethernet PHY with RMII
- 16 bit data bus at SODIMM200
- 22 bit address bus at SODIMM200
- External NAND/NOR/CF interface
- 6-channel audio front-end interface (AC97)
- USB 2.0 host and device
- 1 Mbps control area network (CAN)
- Debug Unit (DBGU)
- UART0/1 at SODIMM200
- Two channel 50 Mbps SPI
- Two channel SDIO interfaces with SDHC support
- 18 bit TFT/STN interface
- MCI controller for CMOS
- Compact form-factor: SODIMM200 (67x46mm)
|
|
|
|
|
|
|
|
|
|
SBC-9263 Product brief
